Noisy pipes, valves, and other air-related noises are often accepted as the signs of a functioning system. Excessive pump noise, cavitation, and cascading in terminal units are considered normal. But air in system water can cause corrosion, reduced efficiency, poorly heated or inadequately cooled rooms, accelerated component wear and on-going complaints. There is a device that will keep your system free of air permanently. Less maintenance, quiet operation, fewer costs!. Unlike conventional air eliminators or air scoops, the Spirovent completely eliminates 100% of the free air, 100% of the entrained air, and up to 99.6% of the dissolved air in the system. Consisting of woven copper wire soldered to a copper tube, the patented Spirotube creates a low velocity area in the Spirovent that scrubs the bubbles from the water. The air bubbles rise and collect in the air chamber before they are vented from the system via an integral automatic valve. Air problems become a thing of the past.

Maintenance free
• No venting required
• Vent head is designed to stay dry, dirt and leak resistant
• 1/2" male thread port for pressure testing or remote venting of unwanted gases
• Quiet operation
• Increased component life
• Reduced oxygen based corrosion and pump cavitation
• The automatic air vent is guaranteed not to leak and can only be closed by the installer for a pressure test
• The air chamber has been designed so that dirt cannot reach the valve
• Large capacity collection chamber reduces the need for frequent draining
• Drain valve for flushing out the dirt
• Brass vent head
• Non-ferrous float
• ViTon seal and o-ring
• Copper cOverall Lengthescing medium
  

  Spirotherm B156-22

Noisy pipes, valves, and other air-related noises are often accepted as the signs of a functioning system. Excessive pump noise, cavitation, and cascading in terminal units are considered normal. But air in system water can cause corrosion, reduced efficiency, poorly heated or inadequately cooled rooms, accelerated component wear and on-going complaints. There is a device that will keep your system free of air permanently. Less maintenance, quiet operation, fewer costs!. Unlike conventional air eliminators or air scoops, the Spirovent completely eliminates 100% of the free air, 100% of the entrained air, and up to 99.6% of the dissolved air in the system. Consisting of woven copper wire soldered to a copper tube, the patented Spirotube creates a low velocity area in the Spirovent that scrubs the bubbles from the water. The air bubbles rise and collect in the air chamber before they are vented from the system via an integral automatic valve. Air problems become a thing of the past.

Maintenance free
• No venting required
• Vent head is designed to stay dry, dirt and leak resistant
• 1/2" male thread port for pressure testing or remote venting of unwanted gases
• Quiet operation
• Increased component life
• Reduced oxygen based corrosion and pump cavitation
• The automatic air vent is guaranteed not to leak and can only be closed by the installer for a pressure test
• The air chamber has been designed so that dirt cannot reach the valve
• Large capacity collection chamber reduces the need for frequent draining
• Drain valve for flushing out the dirt
• Brass vent head
• Non-ferrous float
• ViTon seal and o-ring
• Copper cOverall Lengthescing medium
  

  Spirotherm B156-21

Taco boiler feed valves automatically feed water to a system whenever pressure in the system drops below the pressure setting of the valve. The dual control models combine the boiler feed with an in-line pressure relief valve. The built-in check prevents emptying the system if incoming pressure falls. They feature fast fill rates and an exclusive, lockable fast fill lever. Each valve is adjustable from10 to 25 psi, has a built-in check to prevent the emptying of the system if incoming pressure fails, and the easy to use fast fill lever is lockable.

Fast fill rate
• Exclusive fast fill lever lock
• Built-in check to prevent emptying the system if incoming pressure fails
• Pressure setting adjustment separated from fast fill lever for easy, fast adjustment
• 100 psi maximum supply side pressure, 30 psi relief valve setting, 12 psi factory setting
  

  Taco B143-12

Bell & Gossett B-38 Cast Brass Pressure Reducing Valve, 1/2", NPT, 10 - 25 psig

Fast fill feature reduces start-up time and labor
• Low inlet pressure check valve help prevent loss of system pressure if the supply water drops below system pressure
• Convenient cleanable strainer is designed to prevent dirt and sediment from entering the system
• Brass body construction is highly resistant to corrosion-ideal for water systems
• Reducing valves protect heating and plumbing systems against excessive line pressures
• Equipped with built-in-strainer and low inlet pressure check valve
• They are factory set at specified limits although adjustment is easily made
• Construction - cast brass body, with special insert diaphragm, EPDM check valve, brass seat, brass with EPDM insert stem, brass valve plate, stainer and strainer nut wetted parts and steel non-wetted parts
  

  Bell & Gossett B138-8A

Watts Regulators series 1450F dual controls regulator and relief Valve are for use in commercial and residential hydronic heating systems to fill the boiler and piping system with water, and to maintain water pressure in the system at all times. It also provides make-up water to the system in the event of system leaks. It consists of an iron and bronze body construction with NPT threaded inlet and outlet connections, an attached iron body, diaphragm relief valve, a tight seating check valve, purge lever for manual purging, and a stainless steel strainer. Series 1450F has high capacity performance and simplified servicing design. It is suitable for use in the boiler feed lines of hydronic heating systems.

Combination fill valve and safety pressure relief valve
• Tight seating check valve
• Purge lever for manual purging
• High capacity
• Stainless steel strainer to protect the valve disc from fouling
• 100 psi working , 15 psi set and 30 psi relief valve setting
  

  Watts Water B144-2

Amtrol Parts 445 Cast Iron Air Purger, 1-1/2", 125 psi, 4" W x 6" H

Separates air from water in closed loop hydronic heating system
• System connection sets the point of no pressure change
• 1-year warranty
• 1/8" NPT top tapping, 1/2" bottom tapping
  

  Amtrol Parts B135-82

Watts Regulators series 1450F dual controls regulator and relief Valve are for use in commercial and residential hydronic heating systems to fill the boiler and piping system with water, and to maintain water pressure in the system at all times. It also provides make-up water to the system in the event of system leaks. It consists of an iron and bronze body construction with NPT threaded inlet and outlet connections, an attached iron body, diaphragm relief valve, a tight seating check valve, purge lever for manual purging, and a stainless steel strainer. Series 1450F has high capacity performance and simplified servicing design. It is suitable for use in the boiler feed lines of hydronic heating systems.

Combination fill valve and safety pressure relief valve
• Tight seating check valve
• Purge lever for manual purging
• High capacity
• Stainless steel strainer to protect the valve disc from fouling
• 15 psi set and 30 psi relief valve setting
  

  Watts Water B144-1

Noisy pipes, valves, and other air-related noises are often accepted as the signs of a functioning system. Excessive pump noise, cavitation, and cascading in terminal units are considered normal. But air in system water can cause corrosion, reduced efficiency, poorly heated or inadequately cooled rooms, accelerated component wear and on-going complaints. There is a device that will keep your system free of air permanently. Less maintenance, quiet operation, fewer costs!. Unlike conventional air eliminators or air scoops, the Spirovent completely eliminates 100% of the free air, 100% of the entrained air, and up to 99.6% of the dissolved air in the system. Consisting of woven copper wire soldered to a copper tube, the patented Spirotube creates a low velocity area in the Spirovent that scrubs the bubbles from the water. The air bubbles rise and collect in the air chamber before they are vented from the system via an integral automatic valve. Air problems become a thing of the past.

Maintenance free
• No venting required
• Vent head is designed to stay dry, dirt and leak resistant
• 1/2" male thread port for pressure testing or remote venting of unwanted gases
• Quiet operation
• Increased component life
• Reduced oxygen based corrosion and pump cavitation
• The automatic air vent is guaranteed not to leak and can only be closed by the installer for a pressure test
• The air chamber has been designed so that dirt cannot reach the valve
• Large capacity collection chamber reduces the need for frequent draining
• Drain valve for flushing out the dirt
• Brass vent head
• Non-ferrous float
• ViTon seal and o-ring
• Copper cOverall Lengthescing medium
  

  Spirotherm B156-23

Watts Water B911 Bronze Combination Fill Valve Feeder and Backflow Preventer, 1/2" Threaded

Pre-assembled for ease of installation
• Easy service accessibility
• High capacity fill valve for quick system filling and purging
• All bronze body construction union NPT x NPT connections
• Installed on the boiler feed line to provide make-up water to the boiler
• The valve shall contain a watts regulator model 9D backflow preventer and model 1156 feed water pressure regulator
  

  Watts Water B911T

Watts Water B911S Bronze Combination Fill Valve Feeder and Backflow Preventer, 1/2" Sweat

Pre-assembled for ease of installation
• Easy service accessibility
• High capacity fill valve for quick system filling and purging
• All bronze body construction union solder x NPT connections
• Installed on the boiler feed line to provide make-up water to the boiler
• The valve shall contain a watts regulator model 9D backflow preventer and model 1156 feed water pressure regulator
  

  Watts Water B911S

Honeywell PV100S Supervent Air Eliminator 1" OD

Honeywell PV100S

Honeywell PV125 Supervent Air Eliminator 1-1/4" FPT

Honeywell PV125