Apollo Valves 10-407-05 Bronze Safety Relief Valve, 3/4", MNPT x FNPT, 30 psig

• Corrosion resistant construction
• Standard stainless steel spring
• Made in USA

Sid Harvey Item #:10-407-05: Replaces Part #:'s : 27620,
,

Apollo Valves 10-408-05 Bronze Safety Relief Valve, 3/4", FNPT x FHPT 30 psig

• Corrosion resistant construction
• Standard stainless steel spring
• Made in USA

Sid Harvey Item #:10-408-05: Replaces Part #:'s : 27621,
,

Honeywell PV-001RP Replacement Air Vent Assembly,
,

Watts Regulator series 100xL temperature and pressure relief valves are used in water heater and hot water storage tank applications to provide automatic temperature and pressure protection to hot water supply tanks and hot water heaters up to 105000 BTU. They feature a bronze body with MNPT inlet and FNPT outlet connections, unique thermostat with special thermo-bonded coating, and a test lever.

• Features a unique thermostat with special thermo-bonded coating
• Stainless steel spring
• Thermostat is accurate and proven and exclusively designed and manufactured by Watts

Sid Harvey Item #:B147-3: Replaces Part #:'s : B147-3A,
,

Spirotherm VDR100FT Spirocombi Air & Dirt Separator 1" FPT W/Magnet

Spirotherm Spirotop VTP Brass Air Release Valve, 1/2", FPT, 150 psig

• Brass vent head
• Non-ferrous float
• ViTon seal and o-ring

,
,

Cello WP7-2-10

Spirotherm Spirovent Junior Microbubble VJP Series Solid Brass Air,
,

Cello WP17-20

Spirotherm Spirovent Junior Microbubble VJP Series Solid Brass Air,
,

Cello WP17-16

Noisy pipes, valves, and other air-related noises are often accepted as the signs of a functioning system. Excessive pump noise, cavitation, and cascading in terminal units are considered normal. But air in system water can cause corrosion, reduced efficiency, poorly heated or inadequately cooled rooms, accelerated component wear and on-going complaints. There is a device that will keep your system free of air permanently. Less maintenance, quiet operation, fewer costs!. Unlike conventional air eliminators or air scoops, the Spirovent completely eliminates 100% of the free air, 100% of the entrained air, and up to 99.6% of the dissolved air in the system. Consisting of woven copper wire soldered to a copper tube, the patented Spirotube creates a low velocity area in the Spirovent that scrubs the bubbles from the water. The air bubbles rise and collect in the air chamber before they are vented from the system via an integral automatic valve. Air problems become a thing of the past.

• Maintenance free
• No venting required
• Vent head is designed to stay dry, dirt and leak resistant
• 1/2" male thread port for pressure testing or remote venting of unwanted gases
• Quiet operation
• Increased component life
• Reduced oxygen based corrosion and pump cavitation
• The automatic air vent is guaranteed not to leak and can only be closed by the installer for a pressure test
• The air chamber has been designed so that dirt cannot reach the valve
• Large capacity collection chamber reduces the need for frequent draining
• Drain valve for flushing out the dirt
• Brass vent head
• Non-ferrous float
• ViTon seal and o-ring
• Copper coalescing medium

Sid Harvey Item #:VJR150TM: Replaces Part #:'s : L38-346,
,

Noisy pipes, valves, and other air-related noises are often accepted as the signs of a functioning system. Excessive pump noise, cavitation, and cascading in terminal units are considered normal. But air in system water can cause corrosion, reduced efficiency, poorly heated or inadequately cooled rooms, accelerated component wear and on-going complaints. There is a device that will keep your system free of air permanently. Less maintenance, quiet operation, fewer costs!. Unlike conventional air eliminators or air scoops, the Spirovent completely eliminates 100% of the free air, 100% of the entrained air, and up to 99.6% of the dissolved air in the system. Consisting of woven copper wire soldered to a copper tube, the patented Spirotube creates a low velocity area in the Spirovent that scrubs the bubbles from the water. The air bubbles rise and collect in the air chamber before they are vented from the system via an integral automatic valve. Air problems become a thing of the past.

• Maintenance free
• No venting required
• Vent head is designed to stay dry, dirt and leak resistant
• 1/2" male thread port for pressure testing or remote venting of unwanted gases
• Quiet operation
• Increased component life
• Reduced oxygen based corrosion and pump cavitation
• The automatic air vent is guaranteed not to leak and can only be closed by the installer for a pressure test
• The air chamber has been designed so that dirt cannot reach the valve
• Large capacity collection chamber reduces the need for frequent draining
• Drain valve for flushing out the dirt
• Brass vent head
• Non-ferrous float
• ViTon seal and o-ring
• Copper coalescing medium

Sid Harvey Item #:B156-23: Replaces Part #:'s : L38-345,
,

Noisy pipes, valves, and other air-related noises are often accepted as the signs of a functioning system. Excessive pump noise, cavitation, and cascading in terminal units are considered normal. But air in system water can cause corrosion, reduced efficiency, poorly heated or inadequately cooled rooms, accelerated component wear and on-going complaints. There is a device that will keep your system free of air permanently. Less maintenance, quiet operation, fewer costs!. Unlike conventional air eliminators or air scoops, the Spirovent completely eliminates 100% of the free air, 100% of the entrained air, and up to 99.6% of the dissolved air in the system. Consisting of woven copper wire soldered to a copper tube, the patented Spirotube creates a low velocity area in the Spirovent that scrubs the bubbles from the water. The air bubbles rise and collect in the air chamber before they are vented from the system via an integral automatic valve. Air problems become a thing of the past.

• Maintenance free
• No venting required
• Vent head is designed to stay dry, dirt and leak resistant
• 1/2" male thread port for pressure testing or remote venting of unwanted gases
• Quiet operation
• Increased component life
• Reduced oxygen based corrosion and pump cavitation
• The automatic air vent is guaranteed not to leak and can only be closed by the installer for a pressure test
• The air chamber has been designed so that dirt cannot reach the valve
• Large capacity collection chamber reduces the need for frequent draining
• Drain valve for flushing out the dirt
• Brass vent head
• Non-ferrous float
• ViTon seal and o-ring
• Copper coalescing medium

,
,

Noisy pipes, valves, and other air-related noises are often accepted as the signs of a functioning system. Excessive pump noise, cavitation, and cascading in terminal units are considered normal. But air in system water can cause corrosion, reduced efficiency, poorly heated or inadequately cooled rooms, accelerated component wear and on-going complaints. There is a device that will keep your system free of air permanently. Less maintenance, quiet operation, fewer costs!. Unlike conventional air eliminators or air scoops, the Spirovent completely eliminates 100% of the free air, 100% of the entrained air, and up to 99.6% of the dissolved air in the system. Consisting of woven copper wire soldered to a copper tube, the patented Spirotube creates a low velocity area in the Spirovent that scrubs the bubbles from the water. The air bubbles rise and collect in the air chamber before they are vented from the system via an integral automatic valve. Air problems become a thing of the past.

• Maintenance free
• No venting required
• Vent head is designed to stay dry, dirt and leak resistant
• 1/2" male thread port for pressure testing or remote venting of unwanted gases
• Quiet operation
• Increased component life
• Reduced oxygen based corrosion and pump cavitation
• The automatic air vent is guaranteed not to leak and can only be closed by the installer for a pressure test
• The air chamber has been designed so that dirt cannot reach the valve
• Large capacity collection chamber reduces the need for frequent draining
• Drain valve for flushing out the dirt
• Brass vent head
• Non-ferrous float
• ViTon seal and o-ring
• Copper coalescing medium

Sid Harvey Item #:B156-22: Replaces Part #:'s : L38-344,
,