• Conveniently place near sinks, washers, water heaters, sump pumpsanywhere leaks could happen. Battery life lasts up to 3 years without incident
• Notification messages can alert you or your family/ friends, wherever you are, while audible (100 dB alarm) alerts sound when you are at home
• Use to detect temperatures that can freeze pipes, and humidity that could damage valuables
• Runs on WiFi - No Extra Hub or hardware purchase required
• Daisy chain extra cable sensors and cover up to 500 feet of space with one leak detector
• Reusable even after detecting an incident
• After an alarm, simply wipe dry the detector and cable sensors and place them back into service
• There is a 5 years warranty for professionally installed devices
• Mounting - Insert the plug from the cable sensor into the cable sensor jack at the end of the previous cable sensor, repeat for additional cable sensors up to a limit of 500 feet of cable sensors

Resideo CHWES41013

• 18 or 20 ga, 3-conductor shielded cable recommended
• 300 feet maximum distance from thermostat

• 18 or 20 ga, 3-conductor shielded cable recommended
• 300 feet maximum distance from thermostat

• Wireless adapters allows easy addition of RedLink enabled thermostats to TrueZone systems
• Use with a RedLink enabled TrueSteam humidification system to communicate and control humidity
• It also controls dehumidifiers like the Honeywell TrueDRY
• Powered by RedLink reliability
• No interference with other wireless devices in the home
• Communicates with Wireless Outdoor Sensor to automatically control humidity to proper levels
• Mount wireless adapter on wall near HVAC equipment or on the duct

• Used to sense temperature if the thermostat is installed in a poor temperature sensing location
• Small remote temperature sensor to match any room decor
• Easy to install and use
• Factory calibrated, no field calibration required
• Mounts on a vertical wall with supplied bracket and mounting hardware
• Sense temperature and humidity remotely, average temperature and humidify and dehumidify in separate location

• The model 3000 is often used to add air conditioning to a heating system
• It converts a 2-wire cable into a 4-wire cable (R, W, Y, G)
• It can also converts a 4-wire cable into a 6-wire cable for 2-stage heating, 2-stage cooling or heat pump conversions
• Fast-Stat wiring extenders electronically add more wires to a control cable
• Saves significant time and expense as compared to repulling of new cables
• Causes no damage to walls or ceilings as compared to access holes that are often needed when re-pulling cables
• The sender and receiver communicate over the existing thermostat cable and/or outdoor unit cable
• Not a wireless system and therefore avoids all the problems that wireless systems may have
• No batteries required, all Fast-Stat models are powered by the existing 24 VAC transformer
• Compatible with all conventional wiring systems using R, C, W, W2, Y, Y2, G, O/B and other terminals
• Works with old and new systems, can be connected to older systems such as thermopile milliVAC, standing pilot systems, intermittent pilot controllers, fan centers, etc.
• Can be used with oil burners, zone controllers and other systems that require"dry contact switching"
• Works over long cable lengths upto 500 feet and more
• FAST-STAT Wiring Extenders do not produce interference with other electronic devices nor are they affected electronic devices that produce large amounts of interference
• Many Fast-Stat wiring extenders can be used in the same building or complex without interference between units
• Low power use, most FAST-STAT models use less than 3 watt of power

• Fast-Stat wiring extenders electronically add more wires to a control cable
• Saves significant time and expense as compared to repulling of new cables
• Causes no damage to walls or ceilings as compared to access holes that are often needed when re-pulling cables
• The sender and receiver communicate over the existing thermostat cable and/or outdoor unit cable
• Not a wireless system and therefore avoids all the problems that wireless systems may have
• No batteries required, all Fast-Stat models are powered by the existing 24 VAC transformer
• Works with old and new systems, can be connected to older systems such as thermopile milliVAC, standing pilot systems, intermittent pilot controllers, fan centers, etc.
• Fast-Stat wiring extenders do not produce interference with other electronic devices nor are they affected electronic devices that produce large amounts of interference
• Many Fast-Stat wiring extenders can be used in the same building or complex without interference between units
• Low power use, most FAST-STAT models use less than 3 watt of power