Snap Disc Roll-Out Switch Open 300 Degrees Manual Reset 1/4" Spade Connect,

White Rodgers 3L12-300

Snap Disc Roll-Out Switch Open 350 Degrees Manual Reset 1/4" Spade Connect,

White Rodgers 3L12-350

White Rodgers Cooling Controls G567-88 Square Electrode W/24" Leads,

White Rodgers Cooling Controls R510-44 Switching Relay

• 120 VAC Input 24 VAC Coil SPST,
  
  
  

  White Rodgers R510-44

White Rodgers Cooling Controls 760-401 Tear Drop Mount Flame Sensor for Hot Surface Igniter, 30" Lead

White Rodgers G568-30

Sid Harvey G393 Thermopile Coupler 36" Spade Connections 750 Mv,

Sid Harvey G393

White Rodgers Cooling Controls Easy Reader 1F95EZ-0671 White 7 days Program Digital Thermostat, 2H/2C, 4H/2C Heat Pump, mV - 30 VAC Battery, 20 - 30 VAC Hardwire, 45 - 99 deg F

• Installer configurable system applications
• 2-time and 2 temperature settings per program (1 setback) heat and cool or selectable 4-time and 4 temperature settings (2 setbacks)
• Energy savings up to 30%, patented pre-programmed schedule simplifies time and temperature programming
• Blue, lighted display for easier low-light viewing, larger, easy-to-read character size, large 1-butTon 1-function keys for easy operation
• Dual fuel capable with built-in smart fuel logic program (no outdoor sensor required)
• Selectable energy management recovery
• Fast (FA) or slow (SL) heating cycle anticipation, exclusive call for service diagnostic indicator
• Compressor lockout protection, electric heat option, milliVAC compatible
• Intuitive menu-driven setup, programming and operation, with audio prompt to confirm entries
• Permanent program retention during power loss
• Indefinite setpoint hold or temporary temperature override
• Temporary temperature override - will override program for 2 hr
• Heating and cooling, heating only or cooling only configuration (installer selectable)
• Setpoint temperature limited range capable
• Maintains room temperature to within plus or minus 1 deg F
• Room temperature display can be recalibrated up to plus or minus 4 deg F
• Audible feedback, ignition module reset
• Battery with power stealing assist
• 5 years limited warranty

Sid Harvey Item #:1F95EZ-0671: Replaces Part #:'s : 39991,

White Rodgers 1F95EZ-0671

White Rodgers Cooling Controls 50N02A-820 DSI Integrated Furnace Control 24 VAC,

white rodgers 50n02a-820

White Rodgers Cooling Controls F50N02-820 Trane Furnace Board,

The 50A65-5165 is an automatic gas interrupted ignition control that employs a microprocessor to continually monitor, analyze, and control the proper operation of the gas burner, inducer, and fan. signals interpreted during continual surveillance of the thermostat and flame sensing element initiate automatic ignition of the burner, sensing of the flame, and system shutoff during normal operation. these controls incorporates system fault analysis for quick gas flow shutoff , coupled with automatic ignition retry upon sensing a fault correction. it is designed as a replacement for the following controls.

• Twinning connection
• Fused to protect low VAC age system transformers
• 1.5 amp valve relay
• 6 amp igniter relay
• 2.2 amp full load - 3.5 amp locked rotor inducer relay
• 14.5 amp full load - 25 amp locked rotor circulator relay
• 1 micro-amp DC minimum current
• 0.10 micro-amp DC max current
• 100 mega-ohm leakage resistance
• Maximum timing specification
• 0.8 sec flame establishing
• 2 sec flame failure response time
• 77 deg F electrical rating
• Flash code diagnostics, controls gas valve, igniter, blower, inducer, 120 VAC humidifier and air cleaner

Sid Harvey Item #:50A65-5165: Replaces Part #:'s : CNT05165 | CNT5165 |,

white rodgers 50a65-5165

White Rodgers Cooling Controls 50E70-820 HSI Integrated Furnace Control, 18 - 30 VAC, 60 Hz

• 1-stage applications
• 120 volt HSI ignition
• Adapter board and harness included
• For packaged units
• Flame current test pins
• Red and green status LEDs
• Standoffs/adapter board mounting
• 0.8 sec flame establishing time, 2 sec flame failure response time at 60 Hz
• Flame current requirements - minimum current to insure flame detection: 1 micro-amp DC, maximum current for non-detection: 0.1 micro-amp DC, maximum allowable leakage resistance: 100 mega-ohm,
  
  

White Rodgers Cooling Controls S84A-410 Class 2 Step Down Transformer, 40 VA, 120 VAC Primary, 25 VAC Secondary, 60 Hz

• Energy limiting design, unaffected by momentary short circuit
• Continued short circuit of secondary will cause primary winding to open in 1 - 2 min without creating a fire hazard

,

White Rodgers T394-100