• Provide intermediate switching of a line voltage device from a low voltage controller
• Integral transformer provides low voltage power for control circuit
• Includes enclosure
• Contact rating: 10.2 amp at 120 VAC, 5.1 amp at 240 VAC full load; 61.2 amp at 120 VAC, 30.6 amp at 240 VAC locked rotor; 10 amp at 120 VAC, 6 amp at 240 VAC resistive Honeywell RA89A1074 Switching Relay, 120 volt Input, 24 VAC Coil at 50/60 Hz, 0.4 amp Coil, SPSTSid Harvey Item #:R510-15R: Replaces Part #:'s : R510-15,
  ,
  
  

• Intermittent ignition kwik-sensor CAD cell relays on oil burner systems with 15, 30 or 45 sec safety timing
• Certain types have unique signal-light feature with glows whenever safety lock-out occurs
• Line voltage safety switch eliminates burner run-on in the event that the motor relay contacts weld closed
• Solid state flame detection circuitry is not affected by vibration or high or low ambient temperatures
• Recycles on momentary flame failure or power interruption
• 4 x 4 Inch junction box, 10 Inch leads mounting
• 2 wire thermostat
• 0.4 amp thermostat anticipator setting
• Safety lock-out lamp White Rodgers Cooling Controls 668-401 Gray Metal Enclosure Kwik-Sensor CAD Cell Relay, 120 VAC, 45 secSid Harvey Item #:R79-6R: Replaces Part #:'s : R79-6,
  ,
  
  

• Provide intermediate switching of a line voltage device from a low voltage controller
• Integral transformer provides low voltage power for control circuit
• Includes enclosure
• Contact rating: 7.4 amp at 120 VAC, 3.7 amp at 240 VAC full load; 44.4 amp at 120 VAC, 22.2 amp at 240 VAC locked rotor; 10 amp at 120 VAC, 6 amp at 240 VAC resistive; 2000 VA (120 - 240 VAC); secondary DC - 1 amp at 12 VDC, secondary millivolt - 300 milli-amp at 750 mV Honeywell RA832A1066 Switching Relay with Internal Transformer, 120 volt Input, 24 VAC Coil at 50/60 Hz, 0.4 amp Coil, DPSTSid Harvey Item #:R520-26R: Replaces Part #:'s : R520-26,
  ,
  
  

• Controls oil burner, oil valve (if desired) and the ignition transformer in response to a call for heat
• Solid state flame sensing circuit
• LED on terminal strip indicates system lockout Remote lockout indication
• Enclosed safety switch with external reset butTon
• Manual trip lever opens safety switch for system maintenance
• Mounts on standard 4 x 4" junction box
• C554A cadmium sulfide flame detector and 24 VAC thermostat required
• With 30 sec safety timing, alarm outputs and manual safety switch

Sid Harvey Remanufactured R75-52R

• Remanufactured with 100% pure, solid silver pyrostat contacts for longer on-the-job service life
• Backed by 2-year warranty
• All new stack relays contain brass contacts covered with a slight silver plating, it wears off as the contacts open and close, exposing the brass surface over time, the exposed surface is a poor conductor and may result in relay failure and nuisance callbacksSid Harvey Item #:R5R: Replaces Part #:'s : 0R541R,
  ,