The Volt Stick is an instrument for safely checking the presence of an AC voltage in cables, wall outlets, fuses, circuit breakers, junction boxes, power tools and appliances. Also, distinguishes between live and neutral wire in single or three phase supplies. No current flow is needed for correct operation of the Volt Stick. When a voltage is detected, a red indicator in the plastic tip of the Volt Stick illuminates. No contact is needed, unit operates at 1/8" distance from device.,
,

Motors & Armatures E52-8

The time-delay characteristics of these fuses typically allows them to be sized closer to the running ampacity of inductive loads to reduce cost and provide improved overcurrent protection. These fuses will override normal equipment current surges to reduce unnecessary fuse openings. Have moderate current limitation.

• True dual-element construction allows sizing of 125% FLA for motor backup protection
• Superior overload and cycling capabilities
• Provides motor overload, ground fault and short-circuit protection
• Helps protect motors against burnout from overloads and also from single phasing on three phase systems
• Current limiting provides component short circuit protection
• Simplifies and improves blackout prevention
• Dual-element fuses can be applied in circuits subject to temporary motor overloads and surge currents to provide both high performance, short circuit and overload protection
• The overload element provides protection against low level over current of overloads and will hold an overload which is five times greater than the ampere rating of the fuse for a minimum of ten seconds

,
,

Bussmann E356-48

Mars FRMT8-2 Magnetic Air Filter Puller,
,

Motors & Armatures FRMT8-2

Mars refrigeration potential relay service kit has become an industry standard since its introduction over fifty years ago. Its long-term reliability and easy replacement have been the key to its success. The wide calibration ranges and the universal bracket make the Mars potential relay service kit a must on every service truck.

• Non-positional
• Wide range of selectivity
• QC-6 kit included with each relay to convert screw-on to push-on
• Instructions and wiring diagram included in each relay
• 35 amp contact
• Universal break-off bracket on each relay, simply snap-off parts not needed

Sid Harvey Item #:R560-50: Replaces Part #:'s : 29049,
,

Motors & Armatures R560-50

Mars 50305 NEMA Class 2 Power Transformer, 40 VA, 120 VAC Primary, 24 VAC Secondary, 50/60 Hz

• Low heat rise
• Open with end bell construction

Sid Harvey Item #:T394-20: Replaces Part #:'s : 3C101,
,

Motors & Armatures T394-20

Mars 50225 Heavy-Duty NEMA Class 2 Power Transformer, 75 VA, 120/208/240/480 VAC Primary, 24 volt Secondary, 50/60 Hz

• Low heat rise
• Open with end bell construction

Sid Harvey Item #:T394-32: Replaces Part #:'s : 1C937,
,

Motors & Armatures T394-32

Mars 050 Shaded Pole Unit Bearing Motor, 115 VAC , 0.62 amp, NEMA 51, 9 W,Sid Harvey Item #:05411: Replaces Part #:'s : 13775,
,

Mars 05811 Watt Motor 16 Watt 1550 RPM 115 VAC CW
,
,

Mars 05444 Watt Motor 16W 115V CW ECM

05444

Mars Azure 2-Speed 1-PH ECM Evaporator Fan Motor, 1/15 - 1/25 HP, 115/230 VAC, 1550 RPM Azure is an electronically controlled 3.3" motor (ECM) that replaces all 1/15 - 1/25 HP, 115/230 volt, and 1550/600 RPM commercial refrigeration evaporator fan motors for walk in cooler/freezer applications. For 1550 RPM, this motor connects easily to the fan controller via a standard Lyall plug. For 2 speed applications, the Lyall plug can be removed and the motor can be wired directly to a separate 2-speed control module using the included second speed tap for 600 RPM. Motor rotation is set using a simple jumper wire. Azure is rated for 115 or 230 volt with nothing to set, plug it in to either voltage and it adapts to the correct voltage.,
,

Mars 11063 Start Capacitor Round

• 108-130 MFD 330 VAC
  ,
  ,