Lovejoy 132-1

Lovejoy 133-3

Standard L type coupling hub materials are either sintered iron
• The L type coupling consists of 2 standard L type hubs and 1 spider
• Unless stated otherwise, hub torque and horsepower ratings assume a SOX(NBR) rubber spider is being used
• Fail safe will still perform if elastomer fails
• No metal to metal contact
• Resistant to oil, dirt, sand, moisture and grease
• More than 850000 combinations of bore sizes
  
  

  Lovejoy 132-2

The J type flanges in sizes 3J and 4J are made from die cast of high strength zinc alloy (tensile strength of 41000 psi) and are furnished bore-to-size
• J flanges are compatible with EPDM or neoprene sleeves
• Each flange has a keyway and (2) set screws, (1) set screw over the key and one at 90 deg to the keyway
• The J type coupling consists of 2 flanges and 1 sleeve
  
  

  Lovejoy 3J-5/8

The J type flanges in sizes 3J and 4J are made from die cast of high strength zinc alloy (tensile strength of 41000 psi) and are furnished bore-to-size
• J flanges are compatible with EPDM or neoprene sleeves
• Each flange has a keyway and (2) set screws, (1) set screw over the key and one at 90 deg to the keyway
• The J type coupling consists of 2 flanges and 1 sleeve
  
  

  Lovejoy 3J-1/2

Unless otherwise specified, S-Flex couplings are supplied with EPDM flexible sleeves
• EPDM has good resistance to commonly used chemicals and is generally not affected by dirt or moisture
• Lovejoy offers flexible sleeve for S-Flex coupling in (3) designs: 1-piece solid, 1-piece split and 2-piece with retaining ring
• The 1-piece split design provides solutions for applications with unique requirements where small shaft separations inhibit the installation of a 1-piece solid sleeve
• Pre-molded teeth along the diameter of the sleeve engage with teeth of the coupling flanges
• No clamps or screws are needed to connect the flanges with the flexible sleeve which securely lock together under torque for smooth transmission of power
• Torque is transmitted through shear loading of the sleeve
• All 3-sleeve materials are highly elastic which permits the S-flex coupling to protect connected equipment from harmful shock loading, vibration and shaft misalignment
  
  

  Lovejoy 4JE

The 1-piece solid design provides solutions for applications with unique requirements where small shaft separations inhibit the installation of a 1-piece solid sleeve
• Pre-molded teeth along the diameter of the sleeve engage with teeth of the coupling flanges
• No clamps or screws are needed to connect the flanges with the flexible sleeve which securely lock together under torque for smooth transmission of power
• Torque is transmitted through shear loading of the sleeve
  
  

  Lovejoy 6JE