Home  > INTERNATIONAL COMFORT PRODUCTS(x)
|◀ 181 - 192 of 1358 ▶|
View:
Multi-position design for horizontal or vertical installation without modification
  • Two sloped condensate pans on each unit for horizontal or vertical applications
  • Standard sloped drain pans and cleanable insulation treatedwith Environmental Protection
    Agency (EPA) registered antimicrobial agent improves indoor air quality
  • High-static design meets a wider range of applications thancompetitive packaged air handler lines
  • Ultra low leak economizer accessory provides ventilation air and free cooling with built in Fault Detection and Diagnostic (FDD) capabilities
  • Single refrigerant circuit on 072 and 091 sizes. Dual refrigerant circuit on 120-336 sizes
  • Dual circuit can be field modified for use on single circuit condensers
  • Cooling coils with mechanically bonded fins provide peak heat transfer
  • Optional 2-speed indoor fan with VFD controller
  • Standard factory-installed thermostatic expansion valve (TXV) with removable power element
  • Easy maintenance - removal of single panel allows access to virtually all components
  • Die-formed galvanized steel casings provide durability and structural integrity. Optional paint is available
  • 24-volt terminal block for control wiring connection
  • Hot water coil, steam coil, and electric heat accessories are available

    International Comfort Products FAS300SAAA2AUA

  • Item#:
    FAS300SAAA2AUA
    Manufacturer Item:
    FAS300SAAA2AUA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    Item#:
    N5H5S36CKAAA
    Manufacturer Item:
    N5H5S36CKAAA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS243LTA0A00A

  • Item#:
    CAS243LTA0A00A
    Manufacturer Item:
    CAS243LTA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Single stage cooling capacity control on all 072-241 models
  • Two stage cooling capacity control on all 120-240 models
  • Round copper tube aluminum plate fin (RTPF) condenser coils on all models
  • Brass suction and liquid line service valves
  • Full perimeter base rail with built-in rigging adapters and fork truck slots
  • Galvanized steel cabinet with pre-painted exterior panels and primer-coated
  • interior panels tested to 500 hours salt spray protection
  • Fully hermetic scroll compressor with crankcase heater
  • Compressor mounted on independent vibration isolators
  • Comfort AlertTM Diagnostic Board
  • LED Go-No-Go and fault code
  • Built in time guard anti-short cycle
  • Phase protection
  • Fault code retention logic
  • Low volt compressor contactor protector
  • All units have high and low pressure switches
  • Direct drive permanently lubricated condenser fan motors
  • Newly designed terminal board facilitates simple safety circuit
    troubleshooting and simplified control box arrangement
  • Outdoor temperature cooling operation range up to 125°F (52°C) and down to 40°F (4°C ) using winter start kit
  • Models with optional low ambient control provide cooling operation down to -20°F (-29°C )
  • All units factory run tested

    International Comfort Products CAS240HEA0A00A

  • Item#:
    CAS240HEA0A00A
    Manufacturer Item:
    CAS240HEA0A00A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS


    International Comfort Products CVA924GKA

    Item#:
    CVA924GKA
    Manufacturer Item:
    CVA924GKA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS


    International Comfort Products C4H7T36AKAAA

    Item#:
    C4H7T36AKAAA
    Manufacturer Item:
    C4H7T36AKAAA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    InternatinOverall Length Comfort Procusts
  • Zone Damper
  • Slip-In
  • Bottom Mount
  • 10 x 18
  • 3 Wire

    International Comfort Products DAMPSLB10X18-B

  • Item#:
    DAMPSLB10X18-B
    Manufacturer Item:
    DAMPSLB10X18-B
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    International Comfort Products Fast Heating Parts KSACN0701AAA Wired Remote Controller 7 Day Programmable 12 HR format

    International Comfort Products Fast Heating Parts KSACN0701AAA

    Item#:
    KSACN0701AAA
    Manufacturer Item:
    KSACN0701AAA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS


    International Comfort Products NXH636GHP

    Item#:
    NXH636GHP
    Manufacturer Item:
    NXH636GHP
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS


    International Comfort Products N4A318GKF

    Item#:
    N4A318GKF
    Manufacturer Item:
    N4A318GKF
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
  • Multi 18-speed, constant torque (MCT) ECM blower motor
  • Enhanced diagnostics with easy to read 3 digit display for faults and status
  • Up to 92.1% AFUE in upflow, horizontal and downflow positions
  • Single-stage gas valve
  • Cabinet air leakage less than 2.0% at 1.0 in. w.c. and cabinet air leakage less than 1.4% at 0.5 in. w.c. when tested in accordance with ASHRAE standard 193
  • Approved for manufactured housing/mobile home applications with accessory (order separately)
  • Select sizes approved for twinning, refer to accessory kit listing
  • All sizes can be installed in air quality management districts with a 40 ng/NOx emissions requirement

    International Comfort Products R92MSN0801716A

  • Item#:
    R92MSN0801716A
    Manufacturer Item:
    R92MSN0801716A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    International Comfort Products Fast Parts 1174017 Piston #73

    International Comfort Products Fast A/C Parts 1174017

    Item#:
    1174017
    Manufacturer Item:
    1174017
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
    |◀ 181 - 192 of 1358 ▶|
    View: