Bell & Gossett L25201 Lubricating Oil 2.5 oz Tube,

Bell & Gossett 112105 EAS-1 Cast Iron Enhanced Air Separator, 1 Inch NPT, 35 gpm Bell & Gossett EAS-1 Enhanced Air Separator is a highly efficient device for removing entrained air bubbles in hydronic systems. The combination diffuser and coalescing medium design makes possible the removal of very small air bubbles from the fluid stream by coalescence at substantial fluid velocity. The diffuser forces the system fluid to cover the entire inlet portion of the coalescing medium. The coalescing medium will collect air bubbles on its stainless steel filaments. As the bubbles coalesce together, they will rise to the top of the separator where they can be released to the atmosphere through the automatic air vent.,

Bell & Gossett EASB-1 JR Enhanced Air Separator, 1", NPT, 150 psi, 250Sid Harvey Item #:112112: Replaces Part #:'s : 3677,
,

Bell & Gossett B138-LF F3 Brass Dual Unit Valve 1/2" NPT 30 PSI Relief x 12 PSI Reducing

Bell & Gossett B138-LF

Bell & Gossett 1BL034 In-Line Circulator Pump, 1/6 HP, 115 VAC , 3400 RPM

bell & gossett pl-75

Bell & Gossett DG0060 Hoffman Condensate Pump Case to Receiver Gasket,
,

Bell & Gossett DG0060

Bell & Gossett 108120 Red Ring Monoflo Copper Reducing Tee 1" x 1" x 1/2" Copper,
,

Bell & Gossett 108119 Red Ring Monoflo Copper Reducing Tee 3/4" x 1/2" x 3/4" Copper,
,

Bell & Gossett 1BL032 In-Line Circulator Pump, 2/5 hp, 115 VAC , 3250 RPM , 50 gpm

• The pumps shall be of the horizontal, permanently lubricated type, specifically designed and guaranteed for quiet operation
• The pumps shall have a steel shaft supported by permanently lubricated, sealed precision ball bearings
• The pumps are to be equipped with a water-tight seal to prevent leakage
• Mechanical seal faces to be carbon on silicon carbide
• The motor shall be non-overloading at any point on the pump performance curve
• The motor shall be of the drip-proof, sealed precision ball bearing, quiet operating construction
• The permanent split-capacitor motor shall be equipped with thermal overload protection
• The series PL features a maintenance-free system, with a self-cleaning particle shield protects the shaft and bearings from system start-up debris
• Easily handles dirty water conditions
• 25% more efficient than competition
• Close coupled dry motor

Bell & Gossett PL-130 Circulator Pump 2" Water Iron 120 VAC,
,

Bell & Gossett 101215
The isolation flange is a combination of an isolation ball valve and a companion flange for circulators. The isolation flange allows easy service or replacement of the circulator without the need to drain the system. The isolation flange fits the Bell & Gossett NRF/NBF/SSF wet rotors, series PL, series 100, HV, PR and LR circulators.

,
,

Bell & Gossett 118830 Steel Impeller, 4-1/4" Diameter

Sid Harvey Item #:118830: Replaces Part #:'s : 40088,
,